Fabric OS Encryption Administrator's Guide
Fabric OS Encryption Administrator’s Guide 99
53-1002159-03
Viewing and editing group properties
2
• “HA Clusters tab” on page 104
• “Tape Pools tab” on page 105
• “Engine Operations tab” on page 107
General tab
The General tab is viewed from the Encryption Group Properties dialog box. To access the General
tab, select a group from the Encryption Center Devices table, then select Group > Properties from
the menu task bar, or right-click a group and select Properties.
NOTE
You can also select a group from the Encryption Center Devices table, then click the Properties icon.
FIGURE 82 Encryption Group Properties dialog box - General tab
The General tab displays the following properties:
• Encryption group name - the name of the encryption group.
• Group status - the status of the encryption group, which can be OK-Converged or Degraded.
Degraded means the group leader cannot contact all of the configured group members.
• Deployment mode - the group’s deployment mode, which is transparent.
• Failback mode - The group’s failback mode, which can be automatic or manual. The failback
mode can be changed by clicking on the field and selecting the desired mode.
• Primary Key Vault IP address - The IP address of the primary key vault, either IPv4 or host
name.
• Primary Key Vault Connection Status - the status of the connection to the primary key vault. In
an operating environment, the status should be Connected.
• Backup key vault IP address - the IP address of the backup key vault.
• Backup Key Vault Connection Status - the status of the connection to the backup key vault, if a
backup is configured.