Access Gateway Administrator's Guide (53-1001760-01, June 2010)

Access Gateway Administrator’s Guide 47

53-1001760-01

Failover

Deleting a preferred secondary N-Port for device mapping (optional)

Use the following steps to remove a secondary N_Port where devices will connect if their first or

primary N_Port, if defined, is unavailable.

1. Connect to the switch and log in using an account assigned to the admin role.

2. To delete an N_Port configured as a failover port for one or multiple devices mapped to a

specific N_Port, enter the ag --delwwnfailovermapping N_Port command with the

“[WWN];[WWN]” option. All of the listed devices will stop using the N_Port if the first N_Port

mapped to the devices is unavailable unless they log in through F_Ports that are mapped to

the N_Port.

The following example removes N_Port 32 as the secondary N_Port for two devices already

mapped to a primary N_Port.

ag --delwwnfailovermapping 32

“10:00:00:06:2b:0f:71:0c;10:00:00:05:1e:5e:2c:11”

To remove an N_Port as a failover port for all devices mapped to the N_Port, enter the ag

--delwwnfailovermapping N_Port command with the --all option.

The following command removes N_Port 32 as the secondary N_Port for all available devices.

ag --delwwnfailovermapping 32--all

Enabling and disabling Failover on a N_Port

Use the following steps to enable or disable failover policy on a specific N_Port.

1. Connect to the switch and log in using an account assigned to the admin role.

2. Enter the ag

--failovershow N_Port command to display the failover setting.

switch:admin> ag --failovershow 13

Failover on N_Port 13 is not supported

3. Enter the ag --failoverenable N_Port command to enable failover.

switch:admin> ag --failoverenable 13

Failover policy is enabled for port 13

4. Enter the ag --failoverdisable N_Port command to disable failover.

switch:admin> ag --failoverdisable 13

Failover policy is disabled for port 13

Enabling and disabling Failover for a port group

Failover policy can be enabled on a port group. To enable or disable use the following steps to

enable or disable failover on all the N_Ports belonging to the same port group.

1. Connect to the switch and log in using an account assigned to the admin role.

2. Enter the ag

--failoverenable -pg pgid command to enable failover.

switch:admin> ag --failoverenable -pg 3

Failover policy is enabled for port group 3