Brocade Error Message Reference Guide v6.0.0 (53-1000600-01, April 2008)

Fabric OS Message Reference 53
53-1000600-01
BL-1012
5
BL-1012
Message <timestamp>, [BL-1012], <sequence-number>,, ERROR, <system-name>, bport <port
number> port int. is disabled. status=0x<interrupt status> Port <port number> will
be re-enabled in 1 minute.
Probable Cause Indicates that the port generated an excessive number of interrupts that might prove
unrecoverable to the switch operation. The port is disabled to prevent the control processor (CP)
from becoming too busy. The bport is the blade port; this number might not correspond to a user
port number.
Recommended
Action
Make sure to capture the console output during this process.
Check for a faulty cable, small form-factor pluggable (SFP), or device attached to the specified port.
On a bladed switch, run the slotPowerOff and slotPowerOn commands.
On a nonbladed switch, reboot or power cycle the switch.
If the message persists, replace the blade or the nonbladed switch.
Severity ERROR
BL-1013
Message <timestamp>, [BL-1013], <sequence-number>,, ERROR, <system-name>, bport <port
number> port is faulted. status=0x<interrupt status> Port <port number> will be
re-enabled in 1 minute.
Probable Cause Indicates that the port generated an excessive number of interrupts that might prove fatal to the
switch operation. The port is disabled to prevent the control processor (CP) from becoming too
busy. The bport is the blade port; this number might not correspond to a user port number.
Recommended
Action
Make sure to capture the console output during this process.
Check for a faulty cable, small form-factor pluggable (SFP), or device attached to the specified port.
On a bladed switch, run the slotPowerOff and slotPowerOn commands.
On a nonbladed switch, reboot or power cycle the switch.
If the message persists, replace the blade.
Severity ERROR
BL-1014
Message <timestamp>, [BL-1014], <sequence-number>,, ERROR, <system-name>, bport <port
number> port int. is disabled. status=0x<interrupt status>.
Probable Cause Indicates that the port generated an excessive number of interrupts that might prove fatal to the
switch operation. The port is disabled to prevent the control processor (CP) from becoming too
busy. The bport is the blade port; this number might not correspond to a user port number.