Brocade Error Message Reference Guide v6.0.0 (53-1000600-01, April 2008)

Fabric OS Message Reference 113

53-1000600-01

FABS-1013

Message <timestamp>, [FABS-1013], <sequence-number>,, ERROR, <system-name>, <Method

name>[<Method tag number>]:Unknown blade type 0x<Blade type>

Probable Cause An unrecognized type of blade has been discovered in the system.

This may be caused by an incorrect FRU header, inability to read the FRU header, or the blade may

not be supported by this platform or Fabric OS version.

Recommended

Action

Verify that the blade is valid for use in this system and this version of Fabric OS.

Try reseating the blade.

If this is a valid blade and reseating does not fix the problem, then replace the blade.

Severity ERROR

FABS-1014

Message <timestamp>, [FABS-1014], <sequence-number>,, ERROR, <system-name>, <Method

name>[<Method tag number>]:Unknown FRU type 0x<FRU Object type>

Probable Cause An unrecognized type of FRU has been discovered in the system.

This may be caused by an incorrect FRU header, inability to read the FRU header, or the FRU may

not be supported by this platform or Fabric OS version.

Recommended

Action

Verify that the FRU is valid for use in this system and this version of Fabric OS.

Try reseating the FRU.

If this is a valid FRU and reseating doesn't help, then replace the FRU.

Severity ERROR

FABS-1015

Message <timestamp>, [FABS-1015], <sequence-number>,, ERROR, <system-name>, <Method

name>[<Method tag number>]:Request to enable FRU type 0x<FRU Object type>, unit

<Unit number> failed. err code <Error code>

Probable Cause Indicates the specified FRU could not be enabled. This is usually an internal Fabric OS problem.

Recommended

Action

Try removing and reinserting the FRU.

Reboot or power-cycle the CP or system.

If the message persists, run the firmwareDownload command to update the firmware.

Severity ERROR