Brocade Error Message Reference Guide v6.0.0 (53-1000600-01, April 2008)

Fabric OS Message Reference 433
53-1000600-01
Chapter
69
SULB System Messages
SULB-1001
Message <timestamp>, [SULB-1001], <sequence-number>, AUDIT, WARNING, <system-name>,
Firmwaredownload command has started.
Probable Cause Indicates that the firmwareDownload command has been entered. This process should take
approximately 17 minutes. The process is set to time out after 30 minutes.
Recommended
Action
Do not fail over or power down the system during firmware upgrade. Allow the firmwareDownload
command to continue without disruption. Do not fail over or power down the system during
firmware upgrade. No action is required.
Run the firmwareDownloadStatus command for more information.
Severity WARNING
SULB-1002
Message <timestamp>, [SULB-1002],<sequence-number>, AUDIT, INFO, <system-name>,
Firmwaredownload command has completed successfully.
Probable Cause Indicates that the firmwareDownload command has completed successfully and switch firmware
has been updated.
Recommended
Action
No action is required. The firmwareDownload command has completed as expected.
Run the firmwareDownloadStatus command for more information. Run firmwareShow to verify the
firmware versions.
Severity INFO
SULB-1003
Message <timestamp>, [SULB-1003], <sequence-number>, AUDIT, INFO, <system-name>,
Firmwarecommit has started.
Probable Cause Indicates that the firmwareCommit command has been entered.
Recommended
Action
No action is required. Run the firmwareDownloadStatus command for more information.
Severity INFO