Brocade Error Message Reference Guide v6.0.0 (53-1000600-01, April 2008)

452 Fabric OS Message Reference

53-1000600-01

SYSC-1003

Message <timestamp>, [SYSC-1003], <sequence-number>, FFDC, CRITICAL, <system-name>,

Chassis config option <Option number read from the chassis option storage device>

is not supported by CP Blade with ID <Blade ID (platform) number from the Active

CP>. Change the chassis configuration <Steps to change chassis configuration>

Probable Cause Indicates that on system startup, the option configuration file corresponding to the chassisConfig

option read could not be found. This indicates that option is not supported on this platform running

this version of the firmware.

It could also indicate that the current option number could not be read from the chassis option

storage device (the world-wide name (WWN) card).

This message occurs only on the Brocade 24000 and 48000.

Recommended

Action

As indicated in the message, run the chassisConfig command to change to one that is valid on this

platform running this firmware. Note that the chassisConfig option 1 should be valid for all

platforms running any valid firmware.

Severity CRITICAL

SYSC-1004

Message <timestamp>, [SYSC-1004], <sequence-number>,, INFO, <system-name>, Daemon

<Daemon name to restart> restart successful

Probable Cause Indicates that a terminated daemon is restarted by system automatically.

Recommended

Action

Use the supportSave command to gather troubleshooting data. No further action is required.

Severity INFO

SYSC-1005

Message <timestamp>, [SYSC-1005], <sequence-number>,, WARNING, <system-name>, Daemon

<Daemon name to restart> is not restarted (Reason: <Restart failure reason>)

Probable Cause Indicates that a terminated daemon is not restarted, either due to restart limit is reached or restart

action fails

Recommended

Action

Use the supportSave command to gather troubleshooting data. Issue a reboot or haFailover

command to recover the system and limit the traffic disruption.

Severity WARNING