Brocade Error Message Reference Guide v6.0.0 (53-1000600-01, April 2008)

528 Fabric OS Message Reference
53-1000600-01
SULB-1035
86
Recommended
Action
Reboot the switch. This will cause the internal image to be relocated again. Use the
firmwareDownloadStatus to monitor the progress. If the problem persists, contact your switch
service provider.
Severity ERROR
SULB-1035
Message AUDIT, <timestamp>, [SULB-1035], ERROR, FIRMWARE, <event-initiator-details>,
<event-location>, , An error has occurred relocation of the internal image.
Probable Cause Indicates that an error has occurred during the relocation of the internal image. The error may be
caused by inconsistent internal firmware image. It may also be caused by the internal Ethernet or
persistent storage hardware failure.
Recommended
Action
Reset the switch. This will cause the internal image to be relocated again. If the problem persists,
contact your switch service provider.
Severity ERROR
SULB-1037
Message AUDIT, <timestamp>, [SULB-1037], ERROR, FIRMWARE, <event-initiator-details>,
<event-location>, , HCL failed. Reboot the switch manually using the reboot
command. However, it will disrupt the FC traffic.
Probable Cause Many reasons can cause HCL to fail, such as domain not confirmed.
Recommended
Action
Run the reboot command to reboot the switch manually.
Severity Error