Converged Enhanced Ethernet Administrator's Guide v6.4.0 (53-1001761-01, June 2010)

Converged Enhanced Ethernet Administrator’s Guide 125
53-1001761-01
Managing and displaying the FCoE login configuration
13
DRAFT: BROCADE CONFIDENTIAL
Perform the following task to configure FIP multicast advertisement intervals.
Clearing logins
Perform the following task to clear logins.
Displaying FCoE configuration-related information
Perform the following tasks to display FCoE-related configuration information.
Managing and displaying the FCoE login configuration
Another important task in administrating FCoE is configuring the FCoE login information.
Enabling or disabling FCoE login
configuration management
The fcoelogincfg command allows only configured Enode VN_ports to log in. Use the fcoelogingroup
command to configure allowed Enode VN_ports. The default is disabled.
Disabling the fcoelogincfg command allows unrestricted login on Enode VN_ports.
Task Command
Configure FIP multicast advertisement intervals.
Syntax is as follows:
• intvl—Specifies the interval in seconds. The
minimum interval value is 0 seconds and
the maximum value is 300 seconds. A value
of 0 cancels the previous advertisement
interval value.
switch:admin> fcoe --fipcfg -advintvl intvl
Task Command
Clear the logins that occurred through a front-end
port or from a device specified by the Enode's
VN_port WWN. Syntax is as follows:
• -teport slot/port—Specifies the slot or port
number.
• -device wwn—Specifies the device WWN.
switch:admin> fcoe --resetlogin -teport slot/port |
-device wwn
Task Command
Display the embedded FCoE port configuration.
Configurations of all the ports are displayed if you
do not specify a specific port.
switch:admin> fcoe --cfgshow [port]
Display information about devices logged into a
specific FCoE F_port.
switch:admin> fcoe --loginshow [port]
Display FIP configurations. switch:admin> fcoe --fipcfgshow