Converged Enhanced Ethernet Administrator's Guide v6.4.0 (53-1001761-01, June 2010)

Converged Enhanced Ethernet Administrator’s Guide 13
53-1001761-01
DRAFT: BROCADE CONFIDENTIAL
Chapter
2
Using the CEE CLI
In this chapter
•Management Tools . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13
•CEE Command Line Interface. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13
Management Tools
The Brocade 8000 runs traditional Fabric OS (FOS) software and can be managed using the same
tools traditionally used for SAN management. Using the FOS Command Line Interface (CLI),
administrators have access to all commands and utilities common to other Brocade switches. In
addition, FOS software on the Brocade 8000 enables Brocade Web Tools to support the following
features for configuring and managing a Converged Ethernet Network:
• CEE interface display and configuration
• FCoE trunk display and configuration
• CEE configuration including link aggregation (LACP), Virtual LANs (VLANs), Quality of Service
(QoS), and LLDP (Link Layer Discovery Protocol)/ DCBX protocol (Data Center Bridging
eXchange)
• FCoE login groups
CEE Command Line Interface
The Brocade 8000 introduces a new CLI designed to support the management of CEE and L2
Ethernet switching functionality. The CEE CLI uses an industry-standard hierarchical shell familiar
to Ethernet/IP networking administrators.
All conventional port-related Fabric OS CLI commands are only applicable to Fibre Channel. These
commands have no knowledge of the Ethernet ports. The CEE features and CEE ports can only be
configured through the CEE CLI interface which is accessed by entering the cmsh command from
the Fabric OS shell.
The system starts up with the default Fabric OS configuration and the CEE startup configuration.
After logging in you are in the Fabric OS shell. For information on accessing the CEE commands
from the Fabric OS shell, see “Accessing the CEE CLI from the Fabric OS shell” on page 15.
Some Fabric OS commands are available in the CEE shell. Enter the fos ? command at the CEE CLI
Privileged EXEC mode command prompt to view the available Fabric OS commands. The traditional
Fabric OS command help found in the Fabric OS shell is not available through the CEE shell.