HP StorageWorks C-Series Fabric Switches for SAN-OS 3.1(2a) and FabricWare 2.1(3) Release Notes (AA-RWEHE-TE, March 2007)

11 MDS Multilayer Director & Multilayer Fabric Switches Release Notes
switch(config)# exit
6. Copy the running configuration into the startup configuration by entering the following:
switch# copy running-config startup-config
Note: The running configuration overwrites the startup configuration.
In the following example, port 9 is being set to 2-Gbps:
switch login: admin
password: <admin password>
switch# config terminal
switch(config)# interface fc 1/9
switch(config-if)# switchport speed 2000
switch(config-if)# exit
switch(config)# exit
switch# copy running-config startup-config
C-Series MDS 9124 Fabric Switch
The MDS 9124 switches have fixed configurations with 8, 16, and 24 full rate 4-Gbps fibre
channel ports. The 8 and 16 port switches can be upgraded in 8 port increments with a software
expansion license.
C-Series MDS 9124e Fabric Switch for HP c-Class
BladeSystem
The MDS 9124e 12-port fabric switch and the MDS 9124e 24-port fabric switch for HP c-Class
BladeSystem have fixed configurations with 8-internal/4-external or 16-internal/8-external full
rate 4-Gbps fibre channel ports. The 12-port switch can be upgraded to the 24-port switch with a
software expansion license.
Note: Refer to HP.com for the latest supported software for the QMH2462 HBA, LPe1105 HBA,
and c-Class Onboard Administrator firmware.
How to acquire a port license on the MDS 9124e
1. Log into the switch using either the management console or telnet
2. Enter your network-admin privileged account by entering your login name and
password
switch login: admin
Password: <admin password>
3. Enter the following command to verify which ports are eligible to receive a license:
switch# show port-license
4. Enter into the configuration mode by entering the following command:
switch# config terminal
5. Enter the following commands to enable a port license: