Cisco MDS 9000 Family Release Notes for Cisco MDS NX-OS Release 4.1(1b) (OL-17675-02, October 2008)

Send documentation comments to [e-mail]
50
Cisco MDS 9000 Family Release Notes for Cisco MDS NX-OS Release 4.1(1b)
OL-17675-02
Caveats
• CSCso36760
Symptom: In Fabric Manager Release 3.3(x), zone set cloning returns an autoZoneEditing error.
The option to clone a zone is missing.
Workaround: This issue is resolved.
• CSCso41087
Symptom: If FCIP is enabled and the SAN-OS is upgraded, the SNMP service will run into
exception and the following syslog message is displayed:
SNMP Operation(165) failed (62) setting error index.
Workaround: This issue is resolved.
• CSCso85603
Symptom: Performing an ISSU from SAN-OS Release 3.3.1c to NX-OS Release 4.1(1b) may fail
when SME has been provisioned on the switch.
Workaround: This issue is resolved.
• CSCsq29607
Symptom: After logging back into Fabric Manager Client, clicking on the Summary tab causes a
disconnect.
Workaround: This issue is resolved.
• CSCsq44360
Symptom: When the startup rising alarm is triggered, the sample value is smaller than the rising
threshold. This should not trigger an alarm.
Workaround: This issue is resolved.
• CSCsq64637
Symptom: All device aliases in Fabric Manager disappear when adding new device aliases.
Workaround: This issue is resolved.
• CSCsq69543
Symptom: Fabric Manager does not update PortChannel changes.
Workaround: This issue is resolved.
• CSCsr11269
Symptom: The fctimer does not work with Cisco Fabric Services (CFS). Commits are not
successful, and changes can not be made. The following error message is displayed:
dctl-m9509-190-NAC-B1(config)# fctimer E_D_TOV 1050 vsan 1
Warning:The vsan will be temporarily suspended when updating the timer value
This configuration would impact whole fabric.
Do you want to continue? (y/n) y
2008 Jul 1 11:34:39 dctl-m9509-190-NAC-B1 %CFS-2-MTS_REJECT: Verification failed
reject MTS message SAP 15:RR-token 0x64f82
Workaround: This issue is resolved.
• CSCsr11845
Symptom: The JAB serial number shows as the secondary serial number (Fox serial number shows
as the primary serial number) in MDS 9100 Series switches. This results in Call Home notifications
with the Fox serial number.
Workaround: This issue is resolved.