Cisco MDS 9200 Series Hardware Installation Guide (OL-16188-01, April 2008)

B-9
Cisco MDS 9200 Series Hardware Installation Guide
OL-16188-01
Appendix B Technical Specifications
SFP Transceiver Specifications
Environmental and Power Requirements Specifications for Cisco 10-Gbps Ethernet X2 Transceiver
Table B-14 provides the power requirement specifications for the Cisco 10-Gbps Ethernet X2
transceiver.
Table B-15 provides the environmental specifications for the Cisco 10-Gbps Ethernet X2 transceivers.
For information about safety, regulatory, and standards compliance, refer to the Regulatory Compliance
and Safety Information for the Cisco MDS 9000 Family.
SFP Transceiver Specifications
The Cisco MDS 9200 Series is compatible with SFP transceivers and cables that have LC connectors.
Each transceiver must match the transceiver on the other end of the cable in terms of wavelength, and
the cable must not exceed the stipulated cable length for reliable communications.
Cisco SFP transceivers provide the uplink interfaces, laser transmit (TX) and laser receive (RX), and
support 850 to 1610 nm nominal wavelengths, depending upon the transceiver.
Use only Cisco SFP transceivers on the Cisco MDS 9200 Series. Each Cisco SFP transceiver is encoded
with model information that enables the switch to verify that the SFP transceiver meets the requirements
for the switch.
Note Generation 2 modules will not support 1-Gbps/2-Gbps SFPs. Generation 2 modules only support 4-Gbps
SFPs.
This section provides the following topics:
• Cisco Fibre Channel SFP Transceivers, page B-10
• Cisco Fibre Channel/Gigabit Ethernet Transceivers, page B-13
• Cisco CWDM SFP Transceivers, page B-15
• Cisco Gigabit Ethernet Transceivers, page B-19
• DWDM Fibre Channel SFP Transceivers, page B-20
Table B-14 Power Requirement Specification for Cisco 10-Gbps Ethernet X2 Transceivers
X2
Average Transmit
Power (dBm)
Average Receive
Power (dBm)
Fiber Loss
Budget (dBm)
Maximum Minimum Maximum Minimum
DS-X2-E10G-SR -1.2 -7.3 -1.0 -9.9 2.6 (50.0
micron-OM3)
Table B-15 Environmental Specifications for Cisco 10-Gbps Ethernet X2 Transceiver
X2
Operating Storage
Maximum Minimum Maximum Minimum
DS-X2-E10G-SR 40°C 0°C 85°C -40°C