Cisco MDS 9200 Series Hardware Installation Guide (OL-16188-01, April 2008)

2-7
Cisco MDS 9200 Series Hardware Installation Guide
OL-16188-01
Chapter 2 Installing the Cisco MDS 9200 Series
Installing the Chassis in a Cabinet or Rack
Step 2 Install the C brackets on the switch as follows:
a. Position one of the C brackets against the side of the switch and align the screw holes as shown in
Figure 2-2 and Figure 2-3. Then attach the bracket to the switch with two of the flat-head
M4
screws.
Note Ensure the C bracket is oriented so that it blocks the fewest airflow holes on the chassis; the holes
should be slightly closer to the bottom of the brackets and the text on the back of the bracket
should be right side up.
b. Repeat with the other C bracket on the other side of the switch.
Figure 2-2 Installing C Brackets onto the Cisco MDS 9200 Series
1 C bracket 2 Screws, M4
MDS 9216i
GE1
LINK
GE2
LINK
5
6
7
8
9
1
0
1
1
1
2
1
3
1
4
1
2
3
4
116892
1 2