HP StorageWorks Storage Mirroring Recover User's Guide (T5437-96008, November 2009)

417 of 739
Statistic Description
Connection
ID
The incremental counter used to number each connection established.
This number is reset to one (1) each time the Storage Mirroring service
is restarted.
Transmit
Mode
● Active—Data is being transmitted from the source to the target.
● Paused—Data transmission has been paused.
● Scheduled—Data transmission is waiting on schedule criteria.
● Error—There is a transmission error.
● Unknown—Cannot determine the transmission status.
Target data
state
● OK—The data on the target is in a good state.
● Mirroring—The target is in the middle of a mirror process. The
data will not be in a good state until the mirror is complete.
● Mirror Required—The data on the target is not in a good state
because a remirror is required. This may be caused by an
incomplete or stopped mirror or an operation may have been
dropped on the target.
● Restore required—The data on the source and target do not
match because of a failover condition. Restore the data from the
target back to the source. If you want to discard the changes on
the target, you can remirror to resynchronize the source and
target.
● Snapshot reverted—The data on the source and target do not
match because a snapshot has been applied on the target.
Restore the data from the target back to the source. If you want to
discard the changes on the target, you can remirror to
resynchronize the source and target.
Target Route The IP address on the target to which the data is being transmitted.
Compression
● On / Level—Data is being compressed at the level specified.
● Off—Data is not being compressed.
Bandwidth
Limit
If bandwidth limiting has been set, this statistic identifies the limit. The
keyword Unlimited means there is no bandwidth limit set for the
connection.
Connected
Since
The date and time when the current connection was made.