HP StorageWorks Storage Mirroring Recover User's Guide (T5437-96008, November 2009)

545 of 739
k. If your original source was using Replicate NT Security by Name, you must
enable that option on the target before you start the restoration. The option is
available on the target’s Server Properties on the Source tab.
l. Click Restore to begin the restoration. You can identify a restoration
connection because it is enclosed in parenthesis ( ) and it has _Restore
appended to the end of the replication set name.
Note:
If your target is a cluster, take the Double-Take Source Connection
resource offline to disconnect the connection.
During the restoration, only the data is restored back to the source. Shares
are not created on the source during the restoration. Shares that were
created on the target during failover will need to be created manually on
the source.
8. Because there are no users accessing the target data, the restoration process is
complete when the Mirror Status is Idle. When the Mirror Status is Idle,
disconnect the restoration connection from the target.
9. Your original connection on the source, if it still exists in the Replication Console,
will be in a Mirror Required state. Right-click the connection and select Mirror,
Start. Select the type of mirror you wish to perform and click OK. When prompted
to start replication, click Yes.
10. Once you have restarted the mirror and replication, you can allow users to
reconnect to the source.