HP StorageWorks Storage Mirroring user's guide (T2558-96073, February 2008)

19 - 18
5103 Failover Info. Started adding drive shares from %1 to
%2.
No action required.
5104 Failover Info. %1 drive shares were taken over by %2. No action required.
5105 Failover Info. Attempting to run the %1 script. No action required.
5106 Failover Info. The %1 script ran successfully. No action required.
5107 Failover Error Error occurred in running %1 script. Verify that the script identified exists
with the proper permissions.
5108 Failover Error The source machine %1 is not
responding to a ping.
This occurs when all monitored IP
addresses on the source machine stop
responding to pings. Countdown to
failover will begin at the first
occurrence and will continue until the
source machine responds or until
failover occurs.
5109 Failover Error The public NIC on source machine %1
is not responding to a ping.
The failover target did not receive an
answer to its ping of the source
machine. Eventually, a failover will
result. Investigate possible errors
(down server, network error, etc.).
5110 Failover Info. The %1 script "%2" is still running. No action required.
5200 Failback Info.. Failback completed for %1. No action required.
5201 Failback Info.. IP address %1 was removed from
target machine's %2 adapter.
No action required.
5202 Failback Error Unable to Failback properly because IP
address %1 was missing a
corresponding SubNet Mask.
Contact technical support.
5300 Monitoring Info. The following IP address was added to
target's monitoring list: %1
No action required.
5301 Monitoring Info. The following IP address was removed
from target's monitoring list: %1
No action required.
5302 Monitoring Info. Drive share information for %1 has
been updated on the target machine.
No action required.
5400 ARP Info. Broadcasted new MAC address %1 for
IP address %2.
No action required.
5500 Service Warning Could not connect to e-mail server.
Check to make sure the SMTP server
%1 is available (error code: %2).
Storage Mirroring could not connect to
your SMTP server or the username
and/or password supplied is incorrect.
Verify that SMTP server is available and
that you have identified it correctly in
your e-mail notification configuration.
Also verify that your username and
password have been entered correctly.
5501 Service Warning E-mail notification could not be
enabled (error code: %1).
This alert occurs if there is an
unexpected error enabling e-mail
notification during service startup.
Check to see if any other errors
related to e-mail notification have been
logged. Also, check to make sure the
Windows Management
Instrumentation (WMI) service is
enabled. If neither of these apply,
contact technical support.
ID Category Severity Event Message Required Response