HP StoreEver 1/8 G2 Tape Autoloader and MSL2024, MSL4048, MSL8048, and MSL8096 Taep Libraries Firmware Release Notes (4.20, 6.10, 8.60, 1120)

Supersedes history
IMPORTANT: When updating the MSL2024 to firmware version 2.00 or higher from firmware 1.70
or 1.80 without first updating to 1.91, you will get an “Invalid Robotic Library firmware” error (83
02). To resolve this issue, update the library firmware a second time to update the robotics firmware
to the proper level.
IMPORTANT: Several configuration settings are reset to defaults if the library is upgrading from
firmware versions 1.70 or 1.80:
• Mailslot is set to disabled.
• Drive 1 SCSI ID is set to 4.
• Drive 2 SCSI ID is set of 5.
• Master Drive (Library LUN hosted by) is set to Drive 1.
• Drive 1 power is set to on.
• Drive 2 power is set to on.
• Library Mode is set to Automatic.
• Autoload Mode is disabled.
• Loop Mode is disabled.
All versions not listed are inactive.
Table 2 1/8 G2 Tape Autoloader firmware versions
StatusReleasedFirmware version
Active9/25/20134.20
Active4/3/20134.10
Table 3 MSL2024 firmware versions
StatusReleasedFirmware version
Active9/25/20136.10
Active4/3/20136.00
Active — bridge only5/31/20061.91
Table 4 MSL4048 firmware versions
StatusReleasedFirmware version
Active9/25/20138.60
Active4/3/20138.40
Table 5 MSL8048 and MSL8096 firmware versions
StatusReleasedFirmware version
Active9/25/20131120
Active4/3/20131100
Effective date
September 25, 2013
6 Supersedes history