HP StorageWorks Optical 3800ux/7100ux Getting Started Instructions (AA969-96002, May 2004)

0.9 m
(3 ft)
50-95
°
F
10-35
°
C
100-240V
Getting connected
1
3
Connect the jukebox to your host computer and
terminate the last device in the SCSI chain.
Plug
the socket
end of the power cord
into the power receptacle on
the bottom of the power distribution
assembly. Route the power cord through the clip
and close it securely around the cord. Continue
routing down through the long cable slot at the
bottom of the right side panel, and out through the
access hole at the lower back of the jukebox.
2
Using a flat-slotted
screwdriver,
remove the two
screws securing
the access panel
to the cabinet.
Warning: This product can only be used
with an HP approved power cord for your
specific geographic region. Use of a non-
HP approved power cord may result in:
1) noncompliance with individual,
country-specific safety requirements;
2) insufficient conductor ampacity that
could result in overheating with potential
personal injury and/or property damage;
and 3) a fractured power cord, which
could cause the internal contacts to be
exposed, which potentially could subject
the user to a shock hazard. HP disclaims
all liability when HP-approved power
cords are not used.
4
2
1
Connect power to the jukebox.
Power on the jukebox and then
power on the host system.
5
(7100ux
shown)
Note the
environmental
considerations.
Sufficient
clearance is
necessary for
installation access.
clip