HP StorageWorks DAT USB Tape Drives User Guide (DW049-90916, June 2010)

4 Installing an external DAT tape drive
In this chapter:
• “Connecting the power and USB cables” on page 31
Please refer to “Installing an internal DAT tape drive” on page 23, if you are installing an internal
DAT tape drive.
Connecting the power and USB cables
NOTE:
The drive is not powered from the USB bus. It must be connected to the mains power supply.
An external HP StorageWorks DAT drive will operate using any voltage in the range 100–240 volts
(0.7 A, 50-60 Hz). No adjustment is needed.
A power cable is provided with your HP StorageWorks DAT tape drive. The USB 2.0 cable is already
fitted to the tape drive, you cannot remove it.
DAT USB Tape Drives 31