7100ux Optical Jukebox Service Manual (AA969-90904, September 2004)

FRU Removal and Replacement

951000ux/1900ux/2300ux and 3800ux/7100ux Optical Jukebox Service Manual

Replacing an Optical Drive — Jukebox Offline

Note: Before replacing a drive, obtain the most current version of the jukebox controller and drive

firmware for the model and option of the jukebox you are servicing.

Note: Online drive repair is not supported for 3800ux/7100ux models.

1. Remove the three right-side panels and the upper and lower RFI panels (see Figure 50).

2. Remove all drive cables for the drive enclosure that contains the failed drive (see

Figure 50).

— #1 - drive power cable (for both drives)

— #2 - drive interface cable (split, one for each drive)

— #3 - drive enclosure fan power cable

— #4 - SCSI cable (to both drives)

3. Remove the T-20 screws from each side of the drive enclosure. Remove the drive

enclosure from the chassis (see #5 on Figure 50).

Figure 50: Removing the Cables and Screws

4. Remove the four T-10 screws holding the top and bottom access plates on the drive

enclosure (see #1 and #2 in Figure 51). Remove the plates.

5. Remove the four T-10 screws that hold the failed drive in the drive enclosure and slide the

drive forward a small amount to give you room to remove the cables. (#3 screws on

Figure 51 hold the upper drive, #4 screws hold the lower drive.)