2300ux Optical Jukebox Conversion Guide (AA994-96001, May 2004)

Converting an MO Jukebox to UDO or Mixed-Media Technology

331000ux/1900ux/2300ux Optical Jukebox Conversion Guide

3. Attach the GPIO cable and single-ended SCSI cable to the new interposer board (see

Figure 18).

Figure 18: Cables attached to new interposer board

4. Secure the interposer board with the 8 screws that held the previous interposer board in

place.

5. Connect the remaining cables (mailslot cable, power cable, display cable, vertical path

clear cable) to the interposer board, just as they were connected to the previous interposer

board.

6. If the jukebox had a configuration module, or if you are expanding the jukebox capacity,

locate the configuration module (existing or new) and install it on the new interposer board

(see Figure 18).

1 68-pin SCSI cable

2 50-pin GPIO cable

3 Mailslot cable port

4 Power cable port

5 Configuration module

6 Display cable port

7 Vertical path clear cable port

8 50-pin single-ended SCSI cable