2300ux Optical Jukebox Conversion Guide (AA994-96001, May 2004)

Converting an MO Jukebox to UDO or Mixed-Media Technology

36 1000ux/1900ux/2300ux Optical Jukebox Conversion Guide

4. Insert the 2 UDO drive assemblies into place at drive locations 1 and 2 (see the label or

Figure 20).

Figure 20: Connection of drive cables and jumpers to the interposer board

5. Secure the UDO drives to the jukebox using 4 T-20 screws, 2 on each side of the drive.

6. Connect the drive power cables to the jukebox.

7. Connect the SCSI drive cables to the interposer board (see Figure 20).

8. If these are the only two drives in the jukebox, connect the jumpers to the interposer board

in the following manner (see Figure 20).

a. Use a jumper to connect the ports for drive 4.

b. Use a jumper to connect the ports for drive 3.

Retrofitting and reinstalling MO drives

If the customer is not building a mixed-media jukebox, do not follow the procedures in this

section. Instead, continue with Testing the conversion, page 40.

If the customer is building a mixed-media jukebox, the MO drives must be retrofitted and

reinstalled in the jukebox after it is converted for UDO and the UDO drives are installed.

Note: Only 14x MO drives can be upgraded and included in a mixed-media jukebox. 2x, 4x, and

8x MO drives are not supported in a mixed-media configuration.

1 Cables for drive 1

2 Cables for drive 2

3 Drive 1

4 Drive 2

5 Drive location 3

6 Drive location 4

7 Jumpers for drive 3

8 Jumper for drive 4