Brocade Access Gateway Administrator's Guide Supporting Fabric OS v7.0.0 (53-1002156-01, April 2011)

Access Gateway Administrator’s Guide 9
53-1002156-01
Enabling and disabling Access Gateway mode
2
When you disable AG mode, the switch automatically reboots and comes back online using the
fabric switch configuration; the AG parameters, such as port mapping, and Failover and
Failback, are automatically removed. When the switch reboots, it starts in Fabric OS Native
mode. To re-join the switch to the core fabric, refer to “Rejoining Fabric OS switches to a fabric”
on page 73.
9. Enter the switchDisable command to disable the switch.
switch:admin> switchdisable
10. Enter the ag command with the ---modedisable option to disable AG mode.
switch:admin> ag --modedisable
11. Enter the ag --modeshow command to verify that AG mode is disabled.
switch:admin> ag --modeshow
Access Gateway mode is NOT enabled
Port state description
Table 3 describes the possible port states.
TABLE 3 Port state description
State Description
No _Card No interface card present
No _Module No module (GBIC or other) present
Mod_Val Module validation in process
Mod_Inv Invalid module
No_Light Module is not receiving light
No_Sync Receiving light but out of sync
In_Sync Receiving light and in sync
Laser_Flt Module is signaling a laser fault
Port_Flt Port marked faulty
Diag_Flt Port failed diagnostics
Lock_Ref Locking to the reference signal
Testing Running diagnostics
Offline Connection not established (only for virtual ports)
Online Port is up and running