HP StorageWorks Fabric OS 6.0.1a release notes (AA-RWFMA-TE, June 2008)

Fabric OS 6.0.0b
fixes
Table 7 lists defects closed in the Fabric OS 6.0.0b firmware release.
Table 7 Fabric OS 6.0.0b closed defects
Closed defect s
ummary
Solution
Auto-negotiation with specificHBAsdoesnotbringtheportstothe
correct maximum speed.
Fixed in Fabric OS 6.0.0b
Brocade 4Gb SAN Switch for HP c-Class BladeSystem
power-on-self-test (POST) failure on chassis power on.
Fixed in Fabric OS 6.0.0b
In a configurati
onwheretherearemultiplepathsconfi gured, some
DC Director po
rt blade paths were observed not coming online.
Fixed in Fabric OS 6.0.0b
Host does not see devices when zone name starts with "red_". Fixed in Fabric OS 6.0.0b
FICON Virtual Tape Pipelining does not function correctly with
specifictapedevices.
Fixed in Fabric OS 6.0.0b
Significant F
CIP performance difference occurs between sending FC
frames out from one por t group to another.
Fixed in Fabric OS 6.0.0b
Firmwareupgradeon4/8SANSwitchand4/16SANSwitchto
Fabric OS 6.x will cause the switch to report marginal state.
Fixed in Fabric OS 6.0.0b
After login to switch using RADIUS server, switch prompt looks
jumbled.
Fixed in Fabric OS 6.0.0b
Syntax of the portbuffershow command is inconsistent with other
CLI commands.
Fixed in Fabric OS 6.0.0b
Fabric OS 6.
0.0c fixes
Table 8 lists defects closed in the Fabric OS 6.0.0c fi rmware release.
Table 8 Fabric OS 6.0.0c closed defects
Closed defe
ct summary
Solution
Under rare conditions when the zoning configuration is changed, a
few frames may be dropped even for zones that are not affected by
thechange(for8Gbswitchesonly).
Fixed in Fabric OS 6.0.0c
Port_scn removes logical paths from wrong port, causing some
paths not to come on line.
Fixed in Fabric OS 6.0.0c
A device may disappear after server reboot in a FICON environment
due to PLOGI being rejected because routing tables not yet
established.
Fixed in Fabric OS 6.0.0c
FICON Tape Pipelining with specific tape devices results in block
count mismatch errors.
Fixed in Fabric OS 6.0.0c
FCIP product only provides up to 2:1 compression ratio when
compression enabled, but should be higher.
Fixed in Fabric OS 6.0.0c
22