7100ux Optical Jukebox Service Manual (AA969-90904, September 2004)

FRU Removal and Replacement

116 1000ux/1900ux/2300ux and 3800ux/7100ux Optical Jukebox Service Manual

9. Rotate the rear of the translate frame up and then remove the frame out to the side (see

Figure 72).

Figure 72: Rotating the Translate Frame Out of the Chassis

Reassembly Notes

Note: Take care to install the translate frame properly. If the frame is not mounted level, errors will

be caused that will prevent the library from operating. The following steps explain proper mounting

of the frame.

1. Place the frame back in the chassis. Let it rest on its support points. The rear of the frame

rests on a ledge on the vertical motor.

2. Pull the tensioners down so that they are next to their mount points on the sides and rear of

the translate frame. Press them into the side of the translate frame.

3. While tightening the mounting screw in a tensioner, push down on the frame at that point

to make sure that the translate frame remains on its lower stop while you tighten the

mounting screw.

4. Check that the translate frame is mounted level on the cables by centering the picker and

pushing the frame down lightly and quickly. If you hear a “click” it means that the frame

has slack and needs adjustment.

If adjustment is necessary, remount the frame on the tensioners as described in Step 3 and

retest.