7100ux Optical Jukebox Service Manual (AA969-90904, September 2004)

FRU Removal and Replacement

130 1000ux/1900ux/2300ux and 3800ux/7100ux Optical Jukebox Service Manual

Checking the RFI Adjustments

Note: The following RFI adjustments must be maintained after servicing the jukebox. Depending on

the service performed, these configurations may be altered. The purpose of this section is to remind

you of the RFI adjustments that must remain in place.

Refer to Figure 84 on the next page for the discussion below.

Be sure that there is an RFI clamp holding the front panel cable to the chassis as shown by #1.

Be sure that the RFI clamps (#3) around the SCSI cable (or cables) below the lower interposer

PCA (#4) are placed as close to the bottom of the interposer PCA as possible.

Place the thin cable clamps on the cables as shown by #5. The goal is to hold the cables as

close to the chassis body as possible.

Figure 84: RFI Adjustments