7100ux Optical Jukebox Service Manual (AA969-90904, September 2004)

Troubleshooting and Diagnostics

32 1000ux/1900ux/2300ux and 3800ux/7100ux Optical Jukebox Service Manual

36 Magazine measure failed

37 Test magazine failed

38 Return magazine failed

39 Clear magazine path

3C Mailslot put in saturate failed

3D Mailslot get out saturate failed

3E Mailslot put in accept failed

3F Mailslot get out accept failed

40 Measurement of mailslot depth failed

41 Recovery did not clear vertical path

42 Rotate mailslot in failed

43 Rotate mailslot out failed

46 Flipped too far

47 Did not flip far enough

48 Flip side incorrect

50 Failed to finish a translate

51 Extra force needed to translate

5A Command received to rotate mailslot but both pickers are full

5B Back sensor in mailslot is bad

5C Front sensor in mailslot is bad

5D Command received to eject from the mailslot, but both pickers are full

5E Attempt to load from an empty mailslot

5F Engaging the mailslot failed on a rotate in

60 Disengaging the mailslot failed on a rotate in

61 Rotate in catch error (not used)

62 Rotate in push out error (not used)

63 Rotate in armed failed (not used)

64 Did not detect hard stop on a rotate in

65 Rotate in was too much distance

66 Engaging the mailslot failed on a rotate out

67 Disengaging the mailslot failed on a rotate out

68 Did not detect hard stop on a rotate out

69 Rotate out distance was too short

6A Could not move thumbs out of the vertical path after a rotate out

6B Vertical distance difference detected after error recovery

6C Cartridge in mailslot incorrectly at rotate in

6D Mailslot rotate in accept fail

Table 6: Micro-move error codes (Continued)

Micro-Move Error

Code (hex)

Description