7100ux Optical Jukebox Service Manual (AA969-90904, September 2004)

FRU Removal and Replacement

64 1000ux/1900ux/2300ux and 3800ux/7100ux Optical Jukebox Service Manual

Replacing the Mailslot Assembly

1. Remove the front panel (refer to“Access for 1000ux/1900ux/2300ux Models” on page 45).

2. Remove the two T-15 mailslot mounting screws from the upper left side of the chassis (see

arrows on the left side of Figure 17).

These screws are recessed. Use a Torx driver with an extended shaft.

3. Unplug the mailslot cable from the interposer PCA.

4. Slide the mailslot out of the jukebox.

Thread the mailslot cable through the slot as you pull the mailslot out of the chassis (see

Figure 17).

Figure 17: Mailslot Assembly Mounting Screws

Reassembly Notes

Thread the mailslot cable down through the slot on the top of the PCA enclosure while

inserting the mailslot into the chassis. After mailslot is installed, connect the mailslot cable to

the interposer PCA.