7100ux Optical Jukebox Service Manual (AA969-90904, September 2004)

FRU Removal and Replacement

66 1000ux/1900ux/2300ux and 3800ux/7100ux Optical Jukebox Service Manual

Replacing an Optical Drive — Jukebox Offline

Note: Before replacing a drive, obtain the most current version of the jukebox controller and drive

firmware for the model and option of the jukebox you are servicing.

Note: Online drive repair is not supported for 1000ux/1900ux/2300ux models.

1. Remove the back panel (see “Access for 1000ux/1900ux/2300ux Models” on page 45).

2. Remove the drive cables for the failed drive from the interposer PCA. The cable group for

drive 1 is shown on Figure 19:

3. Remove the T-20 enclosure mounting screw on the enclosure holding the failed drive. The

mounting screws for both drives are shown in Figure 19).

Figure 19: Removing Drive Cables and Enclosure Mounting Screw

4. Carefully slide the drive enclosure back and out of the chassis. Avoid catching the

enclosure on cables connected to the other drive enclosures.