7100ux Optical Jukebox Service Manual (AA969-90904, September 2004)

FRU Removal and Replacement

92 1000ux/1900ux/2300ux and 3800ux/7100ux Optical Jukebox Service Manual

Checking the RFI Adjustments

Note: The following RFI adjustments must be maintained after servicing the jukebox.

Depending on the service performed, these configurations may be altered. The purpose of this

section is to remind you of the RFI adjustments that must remain in place.

Be sure that there is an RFI clamp holding the SCSI and GPIO cable together as shown in

Figure 47. (Clamp (#1) has end clips (#2) to hold the two plates together.

Be sure that there are cable clamps holding the SCSI and GPIO cables to the side of the

jukebox as shown in Figure 48.

Be sure that there is an EMI strip installed on the right-side panel as shown in Figure 49.

Figure 47: RFI Clamp on the GPIO and SCSI Cables