7100ux Optical Jukebox Service Manual (AA969-90904, September 2004)

FRU Removal and Replacement

971000ux/1900ux/2300ux and 3800ux/7100ux Optical Jukebox Service Manual

8. If there is a disk in the drive, use a disk eject tool to remove the disk from the drive.

a. Insert the eject tool (or paper clip) into the disk eject access hole (see Figure 53).

b. When you feel firm pressure on the tip, push forward. The disk mechanism will eject

the disk.

Note: Remember whether the “A” or “B” side faces up when you remove the disk. The disk must be

inserted into the replacement drive with the same orientation.

Figure 53: Disk Eject Hole

9. Slide the replacement drive into the enclosure nearly all the way. Leave room to connect

the drive cables to the rear of the drive.

10. Connect the drive power cable, SCSI cable, and drive interface cable to the rear of the

drive (see Figure 52).

While placing the drive interface cable onto the drive, slip the plastic cable guide around

the interface cable, remove the adhesive backing, and stick the guide to the rear of the

drive.

11. Insert and tighten the four T-10 screws that mount the drive into the enclosure (see

Figure 51).

12. If a disk was removed from the failed drive, replace the disk into the drive in the same

orientation.

13. Insert the drive enclosure into the chassis and secure the enclosure with two T-20 screws

(see #5 on Figure 51).

14. Connect all drive cables to the interposer PCA (see Figure 50).

15. Turn on the jukebox.

16. Go the INFO * menu and check the current firmware revision level of the jukebox under

REVISION and for the drives under DRIVE FW *.

17. Download firmware if necessary. Refer to “Using HP StorageWorks Library and Tape

Tools” on page 42.

18. If a download is not necessary, replace the lower RFI panel and the three right-side panels.