7100ux Optical Jukebox Service Manual (AA969-90904, September 2004)

FRU Removal and Replacement

98 1000ux/1900ux/2300ux and 3800ux/7100ux Optical Jukebox Service Manual

Replacing a Media Detect Station

1. Remove the two lower right-side panels and the lower RFI panel (see Figure 4).

2. The media detect station is located in drive position 11/12 (the lowest drive position).

Remove the fan cable from the media detect station.

Note: Note the orientation of the media detect station before removing it from the drive enclosure. It

occupies drive position 11, though the drive enclosure occupies both 11 and 12.

3. Remove the media detect station from the drive enclosure:

a. Remove the T-15 screw securing the media detect station sleeve (black plastic) to the

sheet metal support, and slide off the sleeve.

b. Unmount the media detect station support (gray sheet metal) from the inside of the

drive module by removing four T-10 screws.

4. Install the new media detect station:

a. Mount the media detect station support (gray sheet metal) to the inside of the drive

module in drive position 11 using four T-10 screws.

b. Slide the media detect station sleeve (black plastic) into the sheet metal support, and

secure it using a T-15 screw.

Caution: To avoid damaging optical media and subsequent data loss, ensure that the

screw does not project into the surface of the plastic on the media detect station.

5. Reattach the media detect station’s fan cable.

6. Reinstall the lower RFI panel and the two lower right-side panels.