Brocade Network Advisor SMI Agent Developer's Guide v11.1.0 (53-1002169-01, May 2011)
Brocade Network Advisor SMI Agent Developer’s Guide 21
53-1002169-01
Fabric profile
3
NOTE
The following properties are mapped with the value specified to differentiate between
Brocade_Fabric and Brocade_SAN instances.
Brocade_Fabric instance:
OtherIdentifyingInfo[] = {"Fabric"}
IdentifyingDescriptions[] = {"SNIA:DetailedType"}
Brocade_SAN instance:
OtherIdentifyingInfo[] = {"SAN"}
IdentifyingDescriptions[] = {"SNIA:DetailedType"}
Brocade_SAN.ElementName properties
The following are the properties of Brocade_SAN.ElementName:
• Brocade_SAN.ElementName is a descriptive name to identify the SAN.
• The default value for ElementName is the Brocade_SAN.Name property value.
• Supports the set operation that is used to set the user-friendly name to SAN. The name can be
up to 15 characters.
NOTE
The default value for Brocade_SAN.ElementName is the Brocade_SAN.Name property vaule.
For more information about Brocade_SAN.ElementName default values, refer to “Rules governing
Brocade_SAN.Name” on page 17.
Limitations
The following are the limitations of the Brocade_SAN.ElementName:
• The ElementName is changed whenever the SAN WWN is changed.
• The SAN user-friendly name is deleted when the fabric is deleted. For example, assume a
fabric with switch1 as principal switch and you configure a SAN Element Name.
- If the firmware is upgraded in the switch1 and it goes down momentarily, then switch2
becomes the principal switch in that fabric and the Element Name is changed to default.
- When the switch1 comes active and becomes the principal switch, then the configured
SAN ElementName is reset to the configured name.
• The SAN element name is reset to the default value when the principal switch WWN is changed
during fabric merge or segmentation.
- For example, assume there are two switch fabrics where switch1 is the seed switch and
switch2 is the principal switch, and SAN Element name is configured. If a switch3 joins the
fabric as a principal switch, then the element name changes to switch3 WWN and the
configured name is lost.