EZSwitchSetup Administrator's Guide v6.4.0 (53-1001344-03, June 2010)
EZSwitchSetup Administrator’s Guide 3
53-1001344-03
Supported switches
1
FIGURE 2 Configuring Internet Explorer
Supported switches
You can use EZSwitchSetup with the following switches:
• Brocade 300 switch
• Brocade 4100 switch
• Brocade 4900 switch
• Brocade 5000 switch
• Brocade 5100 switch
• Brocade 5300 switch
• Brocade 7800 switch
• Brocade 8000 switch
• Brocade VA-40FC switch
Your switch must meet the following requirements:
• It must be connected to an Ethernet LAN that is accessible by the host. If it is not, the system
issues the message “Page not Found.”
• It must have licensed FC ports. If the switch has no licensed FC ports, you must first install a
POD license and then enable the affected ports. For more information, refer to the section
“Add port license” on page 36
• It must be in a single-switch fabric. If your switch connects to another switch (if there is an
E_Port on the switch), you cannot manage the switch using EZSwitchSetup until you
disconnect the switch connection.
Configure your browser to
check for newer versions of
stored pages on every visit to
the page.