Brocade Secure Fabric OS Administrator's Guide (53-1000244-01, November 2006)

B-2 Secure Fabric OS Administrator’s Guide
Publication Number: 53-1000244-01
B
Table B-1 Secure Fabric OS Commands
Command Role Description Secure Mode
or Non-
Secure Mode?
Which
Switches
in Secure
Mode?
authUtil admin /
fabricAdmin
Displays current authentication parameters and
lets you set the protocol used to authenticate
switches.
Both Any
pkiCreate admin Re-creates the PKI objects on the switch. See
“Creating PKI Objects” on page 2-5.
Nonsecure mode n/a
pkiRemove admin Removes the PKI objects from the switch. Nonsecure mode n/a
pkiShow All users Displays the status of the PKI objects and
digital certificate on the switch. See “Verifying
the Digital Certificate” on page 2-4.
Both Any
secActiveSize admin /
fabricAdmin
Displays the size of the active Secure Fabric OS
database.
Both Any
secAuthSecret admin /
fabricAdmin
Displays, sets, and removes secret key
information from the database or deletes the
entire database.
Both Any
secCertUtil admin /
fabricAdmin
Manages third-party PKI-based SSL certificates
in the switch.
Both Any
secDefineSize admin /
fabricAdmin
Displays the size of the defined Secure Fabric
OS database.
Both Any
secFabricShow admin /
fabricAdmin
Displays Secure Fabric OS-related fabric
information. See “Displaying General Secure
Fabric OS Information” on page 4-2.
Secure mode Any
secFCSFailover admin /
fabricAdmin
Transfers the role of the primary FCS switch to
the next switch in the FCS policy. See “Failing
Over the Primary FCS Switch” on page 3-10.
Secure mode Backup FCS
switch
secGlobalShow admin /
fabricAdmin
Displays current state information for Secure
Fabric OS, such as version stamp and status of
transaction in progress.
Both Any
secHelp admin /
fabricAdmin
Displays a list of Secure Fabric OS commands.
To use, enter the secHelp command at the CLI
prompt.
Both Any
secModeDisable admin /
fabricAdmin
Disables secure mode. See “Disabling Secure
Mode” on page A-2.
Secure mode Primary
FCS switch
secModeEnable admin /
fabricAdmin
Enables secure mode. See “Enabling Secure
Mode” on page 3-2. This command cannot be
entered if secure mode is already enabled unless
all the FCS switches have failed.
Nonsecure mode
Available in
secure mode if
no FCS switches
are left
Enter from
intended
primary FCS
switch