Brocade Access Gateway Administrator's Guide (53-1000605-01, October 2007)

18 Access Gateway Administrator’s Guide
53-1000605-01
Enabling Access Gateway mode
2
If the parameter is set to ‘0’, continue to the next step. If the parameter is not set to ‘0’,
change the parameter and reboot the switch.
4. Enter the ag
--modeenable command to enable Access Gateway mode.
switch:admin> ag --modeenable
The switch automatically reboots and comes back online in Access Gateway mode using a
factory default F_Port to N_Port mapping. For more information on which ports are mapped by
default, refer to Appendix A, “Default Port Mapping”.
5. Enter the ag
--modeshow command to verify that Access Gateway mode is enabled.
switch:admin> ag --modeshow
Access Gateway mode is enabled.
6. Enter the ag --mapshow command without any options to display all the mapped ports.
The following example shows a reconfigured mapping; three N_Ports: 17, 19 and 20 have no
mappings and are not connected to the fabric.
switch:admin> ag --mapshow
N_Port Configured_F_Ports Current_F_Ports Failover Failback PG_ID PG_Name
-----------------------------------------------------------------------------------
0 9;10 None 1 1 N/A N/A
17 None None 1 1 N/A N/A
18 3;4 None 1 1 N/A N/A
19 None None 1 1 N/A N/A
20 None None 1 1 N/A N/A
21 1;2;11;12 1;2 1 1 N/A N/A
22 5;13;14 5 1 1 N/A N/A
23 6;15;16 6 1 1 N/A N/A
TABLE 4 Port State Description
State Description
No _Card No interface card present
No _Module No module (GBIC or other) present
Mod_Val Module validation in process
Mod_Inv Invalid module
No_Light The module is not receiving light
No_Sync Receiving light but out of sync
In_Sync Receiving light and in sync
Laser_Flt Module is signaling a laser fault
Port_Flt Port marked faulty
Diag_Flt Port failed diagnostics
Lock_Ref locking to the reference signal
Testing running diagnostics
Offline Connection not established (only for
virtual ports)
Online The port is up and running