Brocade Access Gateway Administrator's Guide (53-1000605-01, October 2007)

26 Access Gateway Administrator’s Guide
53-1000605-01
Determining the mapping and port status
4
The following information displays.
switch:admin> ag --mapshow
N_Port Configured_F_Ports Current_F_Ports Failover Failback PG_ID PG_Name
-----------------------------------------------------------------------------------
0 9;10 None 1 1 N/A N/A
17 None None 1 1 N/A N/A
18 3;4 None 1 1 N/A N/A
19 None None 1 1 N/A N/A
20 None None 1 1 N/A N/A
21 1;2;11;12 1;2 1 1 N/A N/A
22 5;13;14 5;9 1 1 N/A N/A
23 6;15;16 6;10 1 1 N/A N/A
-----------------------------------------------------------------------------------
To display an N_Port map
1. Connect and log in to the switch.
2. Enter the ag
--mapshow command and specify the port number to display the values of the
the N_Port flivver and failback policies and the mapped F_Ports.
switch:admin> ag --mapshow 0
N_Port : 0
Failover(1=enabled/0=disabled) : 1
Failback(1=enabled/0=disabled) : 1
Current F_Ports : 2;8
Configured F_Ports : 2
PG_ID : 0
PG_Name : pg0
N_Port Port numbers of ports locked in N_Port mode.
Configured F_Ports List of F_Ports that are mapped to the corresponding N_Port.
For example, in the following sample output, F_Ports 9 and 10
are mapped to N_Port 0.
Current F_Ports Shows the F_Ports that are currently connected to the fabric on
the corresponding N_Port.
In the case of failover, the Current F_Ports and Configured
F_Ports differ. For example, in the following ag--mapshow
sample output, ports 9 and 10 are mapped to 0. However, 0 is
offline and therefore, 9 and 10 failed over to 22 and 23.
Failover and Failback Indicates whether the N_Port policy is enabled (1) or disabled
(0).
PG_ID and PG_Name Indicates whether the Port Grouping policy is enabled (1) or
disabled (0).