Brocade Access Gateway Administrator's Guide (53-1000605-01, October 2007)

36 Access Gateway Administrator’s Guide
53-1000605-01
Managing policies
4
To enable APC
1. Connect and log in to the switch.
2. Enter the configupload command to save the switch’s current configuration.
3. Enter the command switchdisable to disable the switch.
4. Enter the command ag --policyenable auto to enable the APC.
5. At the command prompt, type Y to enable the policy.
switch:admin> ag --policyenable auto
All Port related Access Gateway configurations will be lost.
Please save the current configuration using configupload.
Do you want to continue? (yes, y, no, n): [no] y
6. Enable the switch.
To disable the APC
1. Connect and log in to the switch.
2. Enter the command switchdisable to disable the switch.
3. Enter the command ag --policydisable auto to enable the APC
4. At the command prompt, type Y to enable the policy.
switch:admin> ag --policydisable auto
Default factory settings will be restored.
Default mappings will come into effect.
Please save the current configuration using configupload.
Do you want to continue? (yes, y, no, n): [no] y
Access Gateway configuration has been restored to factory default
5. Enable the switch.