Brocade Access Gateway Administrator's Guide (53-1000605-01, October 2007)

44 Access Gateway Administrator’s Guide
53-1000605-01
ag
D
--failbackdisable <N_Port>
Disables the Failback policy for the specified N_Port.
--failbackenable <N_Port>
Enables the Failback policy for the specified N_Port.
--failbackshow [N_Port]
Displays the Failback policy for all the N_Ports. If an optional N_Port is
specified, then the failback policy for that N_Port is displayed.
--failoverdisable <N_Port>
Disables the Failover policy for the specified N_Port.
--failoverenable <N_Port>
Enables the Failover policy for the specified N_Port.
--failovershow [N_Port]
Displays the Failover policy for the specified N_Port.
--mapadd <N_Port> “<F_Port1;F_Port2;...>”
Adds F_Ports to an existing N_Port mapping. An F_Port can be mapped to
only one N_Port. Specify the N_Port number to which the F_Ports are to be
mapped. These F_Ports will be added to the N_Ports
Configured F_Ports
list
.
--mapdel <N_Port> “<F_Port1;F_Port2;...>”
Removes the specified F_Ports from the N_Port mapping. Specify the N_Port
number to which the F_Ports are currently mapped. Specify the list of F_Port
numbers to be removed from the current mapping. The F_Port numbers must
be separated by semicolons.
--mapset <N_Port > “<F_Port1;F_Port2;...>”
Maps F_Ports to a specific N_Port to the fabric. Any F_Port can be mapped to
only one N_Port. F_Ports are enabled only if the N_Port is online and NPIV is
enabled on the fabric port that is connected to Access Gateway.
--mapshow [N_Port]
Displays the F_Ports that are mapped to a given N_Port. N_Port is optional
and if used, it displays the F_Ports that are mapped to the specified N_Port
only. If Port Grouping is enabled, the ID and Name of the Port Group to which
this N_Port belongs is displayed.
--modedisable Disables Access Gateway mode for a switch.
--modeenable Enables Access Gateway mode for a switch.
--modeshow Displays current mode of the switch, wither AG mode or Non-AG mode.
--pgadd <PG_ID> “<N_Port1;N_Port2;…>”
Adds N_Ports into an existing port group ID. Specify the port group ID. Specify
the N_Ports you want to add. The N_Port numbers must be separated by
semicolons.