Brocade Access Gateway Administrator's Guide (53-1000605-01, October 2007)

46 Access Gateway Administrator’s Guide
53-1000605-01
ag
D
--prefdel “<F_Port1;F_Port2; ...>” <N_Port>
Deletes the N_Port as the secondary N_Port for the specified list of F_Ports.
Specify the F_Ports. Specify the N_Port. The F_Port numbers must be
separated by semicolons.
--prefset “<F_Port1;F_Port2; ...>” <N_Port>
Sets this N_Port as the secondary N_Port for the list of F_Ports specified.
Specify the F_Ports. Specify the N_Port. The F_Port numbers must be
separated by semicolons.
If there is a current Preferred port already set for a F_Port, this command will
overwrite that with the new Preferred Port for the F_Port.
An F_Port cannot have more than one N_Port as a secondary N_Port at the
same time. This check will be performed before the mapping is set.
--prefshow Displays the secondary N_Port for each F_Port.
--show Displays the current AG settings that include AG specific switch info, Fabric
Info, N_Port and F_Port info.