Brocade Fabric Manager Administrator's Guide v6.1.0 (53-10000610-02, June 2008)

268 Fabric Manager Administrator’s Guide
53-10000610-02
Ports that completed the RNID exchange
19
2. Click Yes in the confirmation dialog box.
The switch is disabled, and Web Tools launches and displays the Configure tab of the Switch
Admin module (see Figure 170 on page 268). See the Web Tools Administrator’s Guide for
instructions on using Web Tools to set the IDID mode.
Afterwards, you must manually enable the switch using either Web Tools or Fabric Manager.
FIGURE 170 Web Tools Switch Admin module, Configure tab
Ports that completed the RNID exchange
The following procedure describes how to identify ports that have completed the request node
identification (RNID) exchange.
Identifying ports that have completed the RNID exchange
1. Launch the FC Port Connectivity View, as described in “View port information” on page 155, or
access the FC Devices tab in the Information panel.
2. Scroll to the right in the FC Port Connectivity View or FC Devices tab to locate the Capability
column.