Brocade Fabric OS Command Reference Manual - Supporting Fabric OS v5.3.0 (53-1000436-01, June 2007)

104 Fabric OS Command Reference Manual
53-1000436-01
configure
2
Zoning Operation Parameters
The Zoning Operation Parameter field is as follows:
Disable NodeName Zone Checking
Specify 1 to disable using node WWN when specifying nodes in the zone database, or specify 0 to
enable using node WWN when specifying nodes in the zone data. The default value is 0. This value
must be set to 1 for interoperability.
RSCN Transmission Mode
The RSCN Transmission Mode fields are described in Table .
End-device RSCN Transmission Mode
Values are as follows:
0 RSCN only contains single PID
1 RSCN contains multiple PIDs
2 Fabric addresses RSCN
Domain RSCN to End-device for switch IP address or name change
Values are as follows:
0 Disabled. No domain RSCN is sent to the end-device for the switch IP address or name change.
1 Enabled. Domain RSCN is sent to the end-device for the switch IP address or name change.
Arbitrated Loop Parameters
The Arbitrated Loop Setting fields are described in the table.
Descriptions of the Arbitrated Loop Parameter fields are as follows:
Send FAN frames?Specifies that fabric address notification (FAN) frames be sent to public loop
devices to notify them of their node ID and address. When set to 1, frames are sent; when set to 0,
frames are not sent.
Enable CLOSE on OPEN received?
If this is set, a CLS is returned immediately to an OPN if no buffers are available. This is required for
TachLite.
TABLE 5 RSCN Transmission Modes
Field Type Default Range
End-device RSCN Transmission Mode number 1 0 to 2
Domain RSCN to End-device for switch IP address or name change number 0 0 to 1
TABLE 6 Configure Command Arbitrated Loop Settings
Field Default Range
Send FAN frames? 1 0 or 1
Enable CLOSE on OPEN received? 4 0 to 4
Always send RSCN? 0 0 or 1