Brocade Fabric OS Command Reference Manual - Supporting Fabric OS v5.3.0 (53-1000436-01, June 2007)

Fabric OS Command Reference Manual 127

53-1000436-01

diagModeShow

Displays diagnostic mode configuration.

Synopsis diagmodeshow

Description Use this command to display the current settings for several diagnostic configuration parameters.

This command is most often used by burn-in scripts to display a summary of the configuration

settings that were in effect when the script was run.

Any automated use of this command should rely only on the names of the specific variables, not on

their exact positions in the output. Earlier versions of this command listed diag.mode.burnin.nExec

instead of Burnin nExec and diag.mode.burnin.nExec instead of Burnin passnum.

You can issue this command on the FR4-18i blade in a Brocade chassis; however, the command is

not supported by the Brocade platform and does not effect any other feature operations. This

availability is offered to maintain consistency across a mixed-blade environment.

The execution of this command is subject to Admin Domain restrictions that may be in place.

Operands none

Examples To display the diagnostic mode:

switch:admin> diagmodeshow

diag.mode* parameters saved in flash:

diag.mode.burnin = 0

diag.mode.burnin.level = 0

diag.mode.burnin.firstPowerUp = Thu Feb 28 01:36:12 2002

diag.mode.esd = 0

diag.mode.gbic = 0

diag.mode.splb = 0

diag.mode.lab = 0

diag.mode.mfg = 0

diag.mode.bplb = 0

diag.ports = TEST (type=INDEX, sz=512): 100.

Burnin passnum = 1

Burnin nExec = 0

Brocade Mode = OFF

Disable Modes Print = OFF

See Also burninLevel, setEsdMode, setGbicMode, setSplbMode