Brocade Fabric OS Command Reference Manual - Supporting Fabric OS v5.3.0 (53-1000436-01, June 2007)

Fabric OS Command Reference Manual 199
53-1000436-01
fcrFabricShow
2
fcrFabricShow
Displays FC Routers on a backbone fabric.
Synopsis fcrfabricshow
Description Use this command to display information about FC Routers that exist in a FC Router backbone
fabric. The existing invocation syntax is maintained for IPv6 support. When IPv6 addresses are not
configured, the output of fabricshow is the same as it is currently.
The message "No active FC Routers found" is displayed if no active FC Routers are present on the
backbone fabric. An active FC Router is an FC Router with at least one enabled EX_Port.
The following information displays for each FC Router found on the backbone fabric:
WWN World Wide Name of the FC Router.
Domain ID The domain ID of the FC Router. This domain ID is relevant only on the
backbone fabric.
Info The Ethernet IP address and switch name of the FC Router. When IPv6
addresses are configured, only the static ipaddress displayes for each FC
router found on the backbone fabric.
EX_Ports List of active EX_Ports for the FC Router and information about these
EX_Ports. This information includes:
EX_Port The port number for the EX_Port.
FID The fabric ID of the EX_Port.
Neighbor Switch Info (WWN, enet IP, name)
The WWN, Ethernet IP address, and switch name of the switch attached to
the EX_Port.
Operands none
Examples To display the FC Routers in the backbone fabric:
switch:admin> fcrfabricshow
FC Router WWN: 10:00:00:05:1e:37:53:3e, Dom ID: 1,
Info: 10.33.59.254, "sprint6"
EX_Port FID Neighbor Switch Info (enet IP, WWN, name)
------------------------------------------------------------------------
N/A
FC Router WWN: 10:00:00:05:1e:37:00:44, Dom ID: 8,
Info: 10.33.59.224, "fcr_sprint_01"
EX_Port FID Neighbor Switch Info (enet IP, WWN, name)
------------------------------------------------------------------------
N/A
See Also fcrPhyDevShow, fcrProxyDevShow, fcrRouteShow, lsanZoneShow, switchShow