Brocade Fabric OS Command Reference Manual - Supporting Fabric OS v5.3.0 (53-1000436-01, June 2007)

388 Fabric OS Command Reference Manual
53-1000436-01
nsZoneMember
2
nsZoneMember
Displays the information of all the online devices zoned with the given device.
Synopsis nszonemember -a | -u | pid | wwn
Description Use this command to display information about all the online devices zoned with the given device.
Issuing this command without operands displays all online devices zoned with the given device.
Each line of output displays:
Type U for unknown, N for N_Port, NL for NL_Port
Pid The 24-bit Fibre Channel address
COS A list of classes of service supported by the device
PortName The device's port World Wide Name (WWN)
NodeName The device's node WWN
Permanent Port NamePhysical N_Port or NL_Port WWN
DeviceType The device’s type
Port Index The port index this device is attached to
Shared Area Whether this device shares an area with other devices
Device Shared in Other ADWhether device is shared in other Admin Domains
There might be additional lines if the device has registered any of the following information (the
switch automatically registers SCSI inquiry data for FCP target devices):
FC4 supported
IP address (node)
IPA
port and node symbolic name (local device only)
fabric port name
hard address and/or port IP address
Operands This command has the following operands:
-a Displays each local device’s online zoned device data, including the PID and
zone alias.
-u Displays all the unzoned devices in the entire fabric. The device data
displayed includes the device PID and zone alias.
pid | wwn Specifies the port ID or WWN, respectively, whose zoned devices are to be
viewed. This operand is required.
Examples To display information about all the online devices zoned with the given device:
switch:admin> nszonemember 0x0416e2
3 local zoned members:
Type Pid COS PortName NodeName SCR
NL 041901; 2,3;10:00:00:00:c9:26:0e:ae;20:00:00:00:c9:26:0e:ae; 3