Brocade Fabric OS Command Reference Manual - Supporting Fabric OS v5.3.0 (53-1000436-01, June 2007)

Fabric OS Command Reference Manual 455

53-1000436-01

portCfgDefault

Restores the port configuration to factory default values.

Synopsis portcfgdefault [slotnumber/][ge]portnumber

Description Use this command to reset any special configuration values on a port to their factory defaults. This

command will disable ports capable of routing persistently, which is the factory default value. You

can view the current port configuration using the portCfgShow command.

This command does not change the state of a port. To make an E_Port go back to the online state,

use either switchDisable/switchEnable or portDisable/portEnable.

The execution of this command is subject to Admin Domain restrictions that may be in place.

Operands This command has the following operands:

slotnumber For bladed systems only, specify the slot number of the port to display,

followed by a slash (/).

portnumber Specify the number of the port to be returned to default values, relative to its

slot for bladed systems. Use switchShow to list valid ports.

Examples To reset a port to factory defaults:

switch:admin> portcfgdefault 1/3

To reset a GbE port to factory defaults:

switch:admin> portcfgdefault 8/ge1

See Also portCfgEPort, portCfgGPort, portCfgLongDistance, portCfgLPort, portCfgPersistentDisable,

portCfgPersistentEnable, portCfgShow, portCfgSpeed, portCfgTrunkPort