Brocade Fabric OS Command Reference Manual - Supporting Fabric OS v5.3.0 (53-1000436-01, June 2007)

458 Fabric OS Command Reference Manual
53-1000436-01
portCfgEXPort
2
-e edtov Specify the E_D_TOV used for port negotiation. Valid values are 1000 -
60000. This operand is only applicable if the "Fabric Parameter" attribute
value is not "Auto Negotiate".
-d domainid Specify the preferred domain ID. Valid values are 1-239.
-p pidformat Specify the Port ID format. Valid values are 0-native, 1-core, 2-extended edge.
This operand is applicable only when port mode is set to 0 (native mode). If
port mode is not "Brocade Native", the Port ID format displays as "Not
applicable".
-t fabric_parameter Specify whether to enable or disable negotiation of the fabric parameters.
Valid values are 1-enable, 2-disable.
-m port mode Specify the Port mode. The -m option will enforce the same port mode for all
the ports connected to the same edge fabric. If -m option is selected, the port
mode will be compared against the online ports. If the modes are different,
an error message will be posted, and the command will fail. Valid values are
as follows:
0 Brocade Native mode.
1 Open McDATA Fabric 1.0 mode (and Brocade Interop mode).
2 McDATA Fabric mode, used when the neighboring McDATA switch is
running OS version such as 6.0.2 or later.
3 McDATA Fabric Legacy mode, for legacy McDATA OS versions such as
5.0.2.
Examples To display the EX_Port configuration of port 2/0:
switch:admin> portcfgexport 2/0
Port 2/0 info
Admin: enabled
State: OK
Pid format: core(N)
Operate mode: Brocade Native
Edge Fabric ID: 16
Front Domain ID: 160
Front WWN: 50:06:06:9e:20:9f:ce:10
Principal Switch: 7
principal WWN: 10:00:00:60:69:c0:05:8a
Fabric Parameters: Auto Negotiate
R_A_TOV: 9000(N)
E_D_TOV: 2000(N)
Edge fabric's primary wwn: N/A
Edge fabric's version stamp: N/A
To set the fabric ID of port 2/1 to 5 and the port ID format to core:
switch:admin> portcfgexport 2/1 -f 5 -p 1
To configure port 2/0 to be an EX_Port and set the fabric ID to 4:
switch:admin> portcfgexport 2/0 -a 1 -f 4
To disable fabric parameter negotiation on port 2/0 of an EX_Port: