Brocade Fabric OS Command Reference Manual - Supporting Fabric OS v5.3.0 (53-1000436-01, June 2007)

Fabric OS Command Reference Manual 465
53-1000436-01
portCfgLongDistance
2
vc_translation_link_init
Specifies the long-distance link-initialization sequence; 1 activates and 0
deactivates this mode. When the command is run without specifying a value,
1 is assigned automatically for the long-distance link in VC_RDY flow control;
otherwise, 0 is assigned. This operand is optional.
desired_distance Refer to the “Description” section for information about the value.
Examples To configure a switch port 63 to support a 100 Km link and be initialized using long-distance link
initialization protocol:
switch:admin> portcfglongdistance 4/15 LS 1 100
switch:admin> portshow 4/15
portCFlags: 0x1
portFlags: 0x20001 PRESENT LED
portType: 1.1
portState: 2 Offline
portPhys: 4 No_Light
portScn: 0
portId: 013f00
portWwn: 20:3f:00:60:69:00:02:48
Distance: super long <= 100km
portSpeed: 2Gbps
Interrupts: 9 Link_failure: 0 Frjt: 0
Unknown: 0 Loss_of_sync: 0 Fbsy: 0
Lli: 9 Loss_of_sig: 9
Proc_rqrd: 0 Protocol_err: 0
Timed_out: 0 Invalid_word: 0
Rx_flushed: 0 Invalid_crc: 0
Tx_unavail: 0 Delim_err: 0
Free_buffer: 0 Address_err: 0
Overrun: 0 Lr_in: 0
Suspended: 0 Lr_out: 0
Parity_err: 0 Ols_in: 0
2_parity_err: 0 Ols_out: 0
CMI_bus_err: 0
See Also configure, portCfgISLMode, portCfgTrunkPort, portCfgShow, portShow, switchShow