Brocade Fabric OS Command Reference Manual - Supporting Fabric OS v5.3.0 (53-1000436-01, June 2007)

Fabric OS Command Reference Manual 473

53-1000436-01

portCfgShow

Displays port configuration settings.

Synopsis portcfgshow [slot/][port]

[slot/][ge]port

Description Use this command to display the current configuration of a port. If no operand is specified, this

command displays port configuration settings for all ports on a switch, except gigabit Ethernet

(GbE) ports. Additionally, use this command to display specific FCIP parameters configured for a

gigabit Ethernet port, such as address resolution protocol (ARP) entries, IP routes, IP interfaces,

FCIP tunnels, and mode. Information varies with the switch model and port type.

The following configuration information displays:

Speed Displays as 1G, 2G, 4G or AN (when in auto speed negotiation mode). This

value is set by the portCfgSpeed command.

Trunk Port Displays as ON when port is set for trunking or blank (..) when trunking is

disabled on the port. This value is set by the portCfgTrunkPort command.

Long Distance Displays the following:

blank (..) Long distance mode is off

LE The link is up to 10 km

LM The link is up to 25 km

L1 The link is up to 50 km

L2 The link is up to 100 km

LD The distance is determined dynamically

LS The distance is determined statically be user input

This value is set by the portCfgLongDistance command.

VC Link Init Displays as blank (..) when the long-distance link initialization option is turned

off and ON when it is turned on for long distance mode. This value is set by

the portCfgLongDistance command.

Locked L_Port Displays as ON when port is locked to L_Port only or blank (..) when L_Port

lock mode is disabled (and it behaves as a U_Port). This value is set by the

portCfgLPort command.

Locked G_Port Displays as ON when port is locked to G_Port only or blank (..) when G_Port

lock mode is disabled (and it behaves as a U_Port). This value is set by the

portCfgGPort command.

Disabled E_Port Displays as ON when port is not allowed to be an E_Port or blank (..) when the

port is allowed to function as an E_Port. This value is set by the portCfgEPort

command.