Brocade Fabric OS Command Reference Manual - Supporting Fabric OS v5.3.0 (53-1000436-01, June 2007)

Fabric OS Command Reference Manual 477

53-1000436-01

portCfgTrunkPort

Configures a port to enable or disable trunking.

Synopsis portcfgtrunkport [slotnumber/]portnumber[,] mode

Description Use this command to enable or disable a port for trunking.

You can disable or enable trunking using the portCfgTrunkPort or switchCfgTrunk commands.

When the command is executed to update the trunking configuration, the ports for which the

configuration applies are disabled and reenabled with the new trunk configuration. As a result, the

traffic through these ports might be disrupted for a period of time.

This command requires a Brocade ISL Trunking license.

The execution of this command is subject to Admin Domain restrictions that may be in place.

Operands This command has the following operands:

slotnumber For bladed systems only, specify the slot number of the port to be configured,

followed by a slash (/).

portnumber Specify a port number to be configured, relative to its slot for bladed systems.

Use switchShow to display a list of valid ports.

mode Specify 1 to enable this port for trunking. Specify 0 to disable the port from

being trunked. This operand is required.

Examples To enable a port for trunking:

switch:admin> portcfgtrunkport 1/3, 1

See Also portCfgShow, portShow, switchCfgTrunk, switchShow